Application Instructions
Read the instructions carefully. The vinyl transfers are easy to put up but cannot be re-used. So please take care when installing them.
Our vinyl transfers can be attached to any flat surface, such as walls, doors, windows, tables, and even in bathrooms (bathtub, tiles etc.). They are water resistant and can be used on any type of vehicle.
Before applying the vinyl transfer, the surface must be cleaned properly so that there is no dust or grease and that it is completely dry. If a wall has recently been painted, please wait for 2 weeks before application.
When handling the vinyl, make sure that the sticky side does not get stuck to itself as it will be impossible to unstick it without damaging it. Ask someone to help you to put the vinyl up if you have to. Just before you put the vinyl up, it is a good idea to use the spatula on the back of the vinyl so that the transfer film will stick to the vinyl picture properly.
Applying a Small Vinyl Transfer (Less than approx. 40cm)
1. Put the vinyl in position on the surface you wish to transfer the picture to and attach it with masking tape.
2. Remove the vinyl (attached to the transfer film) from the white paper, making sure that all of the design is attached to the transfer film, if not then rub it until it sticks.
3. Use the spatula press down firmly from the centre to the edges, avoiding ripples and air pockets. Remove the rest of the white paper scraping towards the bottom with the spatula.
4. Rub the surface of the transparent film with the spatula so that the picture sticks to the wall properly.
5. Slowly remove the transparent film, make sure that none of the vinyl sticker is removed by the transfer film.
6. And now, enjoy living with your MuralDecal vinyl sticker.
Read the instructions carefully. The vinyl stickers are easy to put up but cannot be re-used. So please take care when installing them.
Our vinyl stickers can be attached to any flat surface, such as walls, doors, windows, tables, and even in bathrooms (bathtub, tiles etc.). They are water resistant and can be used on any type of vehicle.
Before applying the vinyl sticker, the surface must be cleaned properly so that there is no dust or grease and that it is completely dry. If a wall has recently been painted, please wait for 2 weeks before application.
When handling the vinyl sticker, make sure that the sticky side does not get stuck to itself as it will be impossible to unstick it without damaging it. Ask someone to help you to put the vinyl up if you have to. Just before you put the vinyl up, it is a good idea to use the spatula on the back of the vinyl so that the transfer film will stick to the vinyl picture properly.
Applying a Large Vinyl Sticker (more than approx. 40cm)
1. Put the vinyl sticker into position against the wall and secure it with masking tape. Put a piece of tape across the middle so it stays in place better.
2. Remove the tape from the top of the vinyl and then begin to remove the silicone paper carefully, making sure that all of the picture is stuck against the transfer film. If not then rub it until it sticks.
3. Cut the white paper across the middle so that the upper part can be attached. Do not forget that the adhesive is very sticky so keep it away from the wall and your clothes.
4. Using the spatula press down firmly from the centre to the edges (of the upper part) avoiding ripples and air pockets.
5. Once the top half is stuck on, remove the rest of the white paper, making sure that the picture is attached to the transfer sheet.
6. Using the spatula press down firmly from the centre towards the edges (on the bottom half) avoiding ripples and air pockets.
7. Remove the transparent film carefully pulling downwards making sure that none of the picture is attached to the transparent film.
8. Finally all you need to do is sit back and enjoy your MuralDecal vinyl sticker.
